President GAS FIRED VENTED ROOM HEATERS MODEL 520AN For Natural Gas MODEL 520AP For L P G (Propane) Gas INSTALLATION & OPE
109. CHECK APPLIANCE OPERATION Depress the control knob. Turn counter clockwise until resistance is felt just before the piezo-electric ignition is
1112. AERATION ADJUSTMENT (See Fig. 15) Natural gas appliances have adjustable shutters to control primary aeration on both rear and front burner tu
12The Outer Case assembly can now be attached to the Heater. Locate the bolts and washers supplied, and fasten the Arched Lintel to the top surface
13MAKE FINAL CHECKS AND INSTRUCT OWNER Make sure that the logs have not been dislodged when fitting the case. Fit the Caution & Direction label
1414. OPERATING PROCEDURE Full lighting instructions are given on the next pages. For your safety this heater is fitted with a Flame Supervision Dev
15FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these i
16LIGHTING INSTRUCTIONS STOP! Read the safety information on previous page. 1. Open the hinged access panel at rear right of case top 2.
1715. CLEANING All cleaning should be carried out when the heater is cold. Normally, the heater should only need dusting. Any stains on the glass
1818 SERVICING INFORMATION - (For qualified service engineers only) The repair parts are shown on the separate repair parts leaflet. Please always
1918.6 TO REMOVE THE PRESSURE REGULATOR 1.Remove the outer case see section 18.3. 2.Disconnect the pipes from each end of the reg
2CONTENTSCONTENTS Page Safety information 3 Installation instructions 4 • General 4 • Rates 4 • Orifice data 4 • Clearances 5 • Floor requi
20 Manufactured by HEATING BIRMINGHAM, ENGLAND Because our policy is one of constant de
3SAFETY INFORMATIONSAFETY INFORMATION Due to high temperatures, the appliance should be located out of traffic and away from furniture and draper
4INSTALLATION INSTRUCTIONS 1. GENERAL This appliance is certified by International Approval Services for use in Canada and the USA. The installati
51.1 CLEARANCES: Make sure that the minimum clearances to combustible materials are maintained during installation including adequate space for the
62. UNPACKING THE HEATER AND CASE CONTENTS OF THE PACKAGES Box 1 of 3 (Heat engine) The carton contains the following:- 1 Heater assembly 3 Cer
7Take the ashlip/front feet assembly and observe the attachment arrangements (see Figure 5) at the rear of the assembly, and place on the floor, in
85. CHECK IGNITION SPARK The pilot electrode is situated at the right side of the firebox above the rear port of the pilot and cross lighting burner
98. LOG INSTALLATION 8.1 Place the rear log (the log with only one short stub) in the retaining cradle behind the rear burner tube with its back aga
Kommentare zu diesen Handbüchern